Како задржати плијесни / калуп за бетонску блоку?

Mould/Mold for Concrete Block is consumables of the machine, so they need to be properly maintained to reduce waste. The maintenance of this mold is very simple. If you follow these maintenance methods, the mold will last longer.

After the machine is finished running, when the Mould/Mold for Concrete Block is taken out, make sure the mold is clean. You can observe whether there is concrete deposits inside the mold and on the positive mold plate. If there is, you can clean it with a wire brush.

The second step is to make sure that the mold is clean. If there is a manual pump, use the manual pump to lubricate the mold eye and the positive mold plate. After lubrication, you can take the mold out of the machine and put it in the storage area. It is worth noting that you must ensure that the storage space is well sealed. Then keep it ventilated. Because the humid environment will cause the mold to rust after a period of time.

If the mold is stored outdoors, be sure to place the mold on a pallet to ensure that the mold is not in direct contact with the ground and cover the mold. In addition, because the mold is exposed to rain, snow and other bad weather, the protective oil will fail and cause mold corrosion. If the mold is not used for a long time, it is best to re-lubricate it every once in a while.

If the Mould/Mold for Concrete Block is well preserved, it can reduce the wear rate of the mold, thereby saving costs.